IMA 流動資訊站

How to fix a 902sh under test program word with Setool?
i tried unlock the phone sucessful but still in test program,and then i press RECOVERY button from setool after the whole process finish my phone cant boot up,anyone know how to fix this problem now???

1) Press Menu + Power and turn on your phone.

2) Connect you phone to a GX32 serial cable

3) Use SPST's shdiag and boot the phone into test mode again

4) Press "Quit (Protect, Format)"

5) Your phone will be formated, wait 15 minutes.

6) Done.

_________________
退一步海闊天空!

i try to run SPST and SHDIAG but it will say operation time out.
how to fix this problem?
i'm using GX30 serial cable and SPST V10

1) Full flash the phone again with SPST

OR

2) If you have SPST install, find this file named "scgd_0block_InitFlagOn.ssw" and flash it to the phone. Than turm it on, the phone will format itself.

_________________
退一步海闊天空!

but now should i use setool or sharp spst to flash?
now my phone can't even power on.

but now should i use setool or sharp spst to flash?
now my phone can't even power on.[/quote]

I will suggest you to use SPST to full flash it.

_________________
退一步海闊天空!

but seems like my SPST doesn't working.
i tried SHdownloader and SHdiag both is not working.
i'm using GX30 com cable,is that correct?
do you have other method to fix this problem?

If you have setool that can unlock Sharp phones, you shall have a special cable. Use this cable to flash the phone with SPST.

_________________
退一步海闊天空!

ok now i know what to do.
but i found got 2 firmware inside the SSW.
1.33H
1.33M
what's the different of this 2 firmware

1.33H = 902SH firmware
1.33M = 802SH firmware
1.33F = 902SH Ferrari

_________________
退一步海闊天空!

thanks kenny!
btw setool has release the sx813 firmware and i'll try to flash later
thanks alot kenny!