IMA 流動資訊站

Hi Kenny,

I am a new user of setool and try to flash the test mode in 903sh and failed. The log:

GUI v0.9137285/UNI
standalone version engaged.
Card serial:0000xxxx
Loaded 49 flash descriptors
llbug: port open error: 00000002
Elapsed:0 secs.
Open COM port OK


The progress bar is running and stopped there.

what's wrong?? can you help? thanks!!

In Device Manager, check what port your cable is using.

Select the right port in setool!

_________________
退一步海闊天空!

i have set the same com port 1 wor....

Check your computer device manager, not setool device manager, if you use pinky 4 in 1 cable , use can see at computer device manager "PINKY Cable (COM?), at SETOOL select same com port.

Comport 1 is not for USB cable. If you are using USB cable, after installing the driver, you can check the comport in Device Manager.

_________________
退一步海闊天空!

i am using cruiser usb cable (need the battery box).

When i first installed the cable, the default port is 33

However, i can only chosoe 1-16 port in Setool.

I try to change to port for the cable in device manager, it shows that port 1-16 are in use....

...so strange

You have to change the port back to 1-33. If you have installed Bluetooth device, delete some Bluetooth Modems and you will free some ports.

_________________
退一步海闊天空!

Dear kenny,

Apart from 4-in-1 com cable, Do I need to have a USB cable to boot the 903SH? (as i see from setool forum)


thx

USB cable is for the power supply so that you don't need battery when flashing the phone.

_________________
退一步海闊天空!

Where can I get the pinky 4-in-1 cable driver? I am new to setool but i can't find the driver anywhere, thanks~

Here

There are 2 types of cable. One is Pinky and th eother one is Cruiser cable. The difference is, Pinky cable does not need external power supply for K750 and Sharp phones.

_________________
退一步海闊天空!